The Homebrew Centre
Your Cart

Taps, Seals And Spares

Fits half inch bore syphon tube. Simply push in to the tube. Ideal for making larger syphon systems with a faster flow...
£3.38
Ex Tax:£3.38
Small tap used for controlling the flow when syphoning. Pushes into standard 5/16 flexible syphon tube.  ..
£1.86
Ex Tax:£1.86
Replacement piercing pin insert for S30 Injector Valve with O ring. Converts standard Stainless Steel S30 Valves to use the 8 gram bulb system. (Als..
£2.94
Ex Tax:£2.94
Replacement float for King Keg and Balliihoo Top Tap Pressure Barrel This can be attached to the back of a barrel tap and floats on the surfac..
£5.87
Ex Tax:£5.87
Standard 2" cap O-ring seal to fit Balliihoo Pressure Barrels & all other barrels with 2" openings. (Not suitable for King Keg)..
£2.40
Ex Tax:£2.40
Replacement Pressure Relief Rubber for Balliihoo Control Cap. (Pack Of 3.)Fits both 2 inch and 4 inch Control Caps. Also fits the 2 inch Vent Cap for ..
£1.18
Ex Tax:£1.18
Replacement O Ring seal to fit various 4 inch barrel caps. The square section rubber cap ring is far superior to the traditional "Round S..
£3.58
Ex Tax:£3.58
Contains a complete set of washers and seals for S30 valves. Please note that the cap seal is a separate item. Consists Of 1 x Cylinder/Bulb S..
£2.93
Ex Tax:£2.93
Replacement inlet seals for S30 valve. 5 Pack.These fit the gas inlet which is the part on the inside of the barrel cap. Suitable for brass or stainle..
£2.93
Ex Tax:£2.93
Pack of 5 pressure release rubbers for S30 valves.  These seals fit on the brass or stainless steel S30 valves. Your original seal m..
£2.93
Ex Tax:£2.93
Replacement small top O Ring for S30 Valves.These replacement O Rings will fit the new stainless steel S30 valves and the older brass type valves.Pack..
£2.93
Ex Tax:£2.93
Pack of 2 Washers to fit between an S30 valve and a cap. Suitable for both the genuine Stainless Steel S30 Valves as well as the brass S30 valves. ..
£1.66
Ex Tax:£1.66
This kit contains all the spare seals you might need for most barrels with a 2" Cap, including the Balliihoo Basic, Youngs & Wilko Barrels. ..
£4.89
Ex Tax:£4.89
This kit contains all the spare seals you might need for most barrels with a 4" cap. This includes King Kegs, Balliihoo Premium Barrels & Rot..
£5.87
Ex Tax:£5.87
1/2 turn on/off operation. Easy to use, has good flow control. Although this tap was designed to be used on wide neck wine fermenters it can a..
£4.17
Ex Tax:£4.17
Brewgas Delux Sparkler Tap - For Kegs and Barrels
Out of Stock
Black plastic lever tap with flip top operation for greater control. Fits into a 1" (25 mm) hole, the standard size for King Kegs, and has a ba..
£19.60
Ex Tax:£19.60
Lever Tap for Cider Barrels
Out of Stock
Replacement tap for a brown cider barrel, complete with washer. There isn't a back nut with these; they are threaded and screw directly in..
£4.89
Ex Tax:£4.89
This can be inserted into any fermenter by drilling a 25mm hole. It is compatible with 3/8" syphon tubing and also the bottling stick. ..
£4.26
Ex Tax:£4.26
Simple to use bottling stick. Simply turn on the lever tap, insert the tube fully into your bottle, when the valve hits the bottom of the bott..
£4.89
Ex Tax:£4.89
Backnut for plastic taps. This backnut will fit all the taps we sell with a 25mm thread, except the cider barrel tap...
£0.83
Ex Tax:£0.83
Food safe silicone based grease with P.T.F.E. Recommended for lubricating the cap seals on pressure barrels. Makes caps easier to tighten giving a lea..
£4.89
Ex Tax:£4.89
Replacement Handle For King Keg, Rotokeg & Wide Neck Fermenter
Out of Stock
This black plastic handle with pin, will fit many of the "twin handled" plastic pressure barrels that are available today, including the King Keg, Rot..
£2.25
Ex Tax:£2.25
Spanner For Fitting Pressure Barrel Taps Spanner For Fitting Pressure Barrel Taps
Out of Stock
"C" Spanner / Wrench for removing, replacing or just tightening standard pressure barrel tapsSuitable for taps without backnuts commonly fitted to Bal..
£8.04
Ex Tax:£8.04
This tap (short spout) screws into the traditional or basic type barrels with a 25mm threaded hole. Supplied complete with rubber sealing wash..
£4.61
Ex Tax:£4.61
Spare washer for Lever Taps and Fermentation Vessel Taps. Please note these are not compatible with Cider Barrel Taps..
£1.23
Ex Tax:£1.23
Spare seal for lever tap for cider barrels.Not compitable with standard Pressure Barrels - please see our other items for pressure barrel tap seals ..
£0.97
Ex Tax:£0.97
Pack of 10 Hambleton Bard Orange Inlet Valve Rubbers. These seals fit on the Hambleton Bard Inlet only valve as found on the Beer-Sphere Barrel. ..
£4.89
Ex Tax:£4.89
Pack of 10 Hambleton Bard Yellow Safety Release Valve Rubbers.Keep the pressure in the barrel, make sure your seals are secure by renewing periodicall..
£5.00
Ex Tax:£5.00
Replacement black O-ring seal for Hambleton Bard Safety Valve. Used on older Roto Kegs and Hambleton Bard Barrels with 4" Caps. (Please note t..
£1.07
Ex Tax:£1.07
Replacement O Ring Seal for Hambleton Bard 4 Inch Red Cap
Out of Stock
Black Round Section O Ring - Fits Old Style Hambleton Bard Barrels And Roto Kegs Will Also Fit The Balliihoo 4 Inch Cap..
£1.81
Ex Tax:£1.81
Spare seal pack for Hambleton Bard/Rotokeg 4" cap with separate inlet & outlet valves.(Please note these are not for King Keg or 2" caps that incl..
£3.14
Ex Tax:£3.14
Showing 1 to 31 of 31 (1 Pages)
We use cookies and other similar technologies to improve your browsing experience and the functionality of our site. Privacy Policy.